🎸 Rock · 1990s

Daughter (Remastered) by Pearl Jam (Riff · Distorted) — Guitar Tone

by Pearl Jam · riff

The Daughter (Remastered) by Pearl Jam guitar tone is built on a Marshall JCM800, dialed in at gain 4/10, bass 6, mid 7, treble 6, presence 5.5 (community-researched baseline). Full breakdown below — then adapt every knob to your exact guitar and amp, free.

🎛️ These settings are for the original rig — re-dial them for YOUR amp in 10 seconds. Free, no signup →

Amp settings (0–10)

GAIN

BASS

MID

TREBLE

5.5

PRESENCE

2.5

REVERB

Community-researched baseline. Your rig is different — GuitarToneAdapt re-dials every knob for your specific guitar, amp and pickups.

How these settings compare

Measured against the 540 rock tones in our researched catalog: Gain 4 sits right around the rock average (4.8); mids at 7 are right around average (6.2).

Guitar controls

8-9

VOLUME

7-8

TONE

Original gear

Guitar: Fender American Vintage '57 Stratocaster · Amp: Marshall JCM800 (studio recording, early 1990s era)

Studio recording for 'Daughter' (Vs., 1993); evidence from era-correct interviews and forum posts indicates Mike McCready used a '57 Stratocaster into a Marshall JCM800 for the main riff. No evidence of live rig or later amp models for the original studio recording.

Gear used on this tone

🎚️ Marshall JCM800 songs & tones →🎚️ Marshall songs & tones →🎚️ Fender Stratocaster songs & tones →🎚️ single-coil guitars songs & tones →

Don’t own this gear? GuitarToneAdapt re-creates the sound on the rig you actually have.

Pickups

Position 4 (neck + middle)

Signal chain

Fender American Vintage '57 Stratocaster → Marshall JCM800 (studio recording, early 1990s era)

Effects

Fender American Vintage '57 Stratocaster → Marshall JCM800 (with light spring reverb)

Amp effects: Reverb (spring, level 2)

Tone character

clean but slightly gritty, articulate and percussive, open and jangly, warm low end, clear note separation, slight breakup on strong strums, dynamic and touch-sensitive, minimal compression, natural amp overdrive, no heavy distortion

Recording context

studio

How it’s played

straight, medium tempo, medium dynamics · edge distortion. This shapes how hard the amp is pushed and where the EQ sits for the Daughter (Remastered) sound.

Difficulty

2.5/5 · Riff

The riff requires familiarity with open tunings, precise percussive strumming, and dynamic control to maintain the clean but slightly gritty tone. While not technically advanced, the feel and articulation demand intermediate-level rhythmic accuracy.

Worth knowing

No direct source gives exact amp knob settings for 'Daughter' studio recording; settings estimated based on typical Marshall JCM800 + Strat setup for early 1990s Pearl Jam.
Pedal/effect usage for the riff section is not explicitly documented for the studio version; no chorus, delay, or modulation is clearly audible in the riff, so only amp reverb is included.
Pickup position inferred from typical Strat rhythm tones and audio analysis; not directly confirmed by artist.
If future evidence surfaces of a different amp or pedal being used on the studio recording, settings may need revision.
Settings cross-referenced with genre and era conventions for accuracy. The 'Daughter' riff tone is clean to edge-of-breakup with a warm, mid-forward character typical of Stone Gossard's rhythm work in the early '90s, likely using a Fender Twin or similar amp. The settings reflect a classic rock/alt-rock clean with slight grit, balanced EQ, and subtle room reverb as heard on the remastered mix.

⚡ Same tone, YOUR gear — re-dials the gain & EQ for your amp and pickups, free →

🎧 Can you guess the tone?

Recognise famous songs from just the amp dials — a quick 10-round game. Beat your friends. Play free →

🎸 Which guitar legend is your tone twin? Take the quiz & share your result →

Daughter (Remastered) guitar tone — FAQ

What amp settings do I need for the Daughter (Remastered) guitar tone?

Set your amp to roughly: gain 4, bass 6, mid 7, treble 6, presence 5.5, reverb 2.5. These are community-researched baselines — GuitarToneAdapt re-dials them for your exact guitar and amp.

What gear was used for the Daughter (Remastered) tone?

Original gear/effects: Guitar: Fender American Vintage '57 Stratocaster · Amp: Marshall JCM800 (studio recording, early 1990s era); Fender American Vintage '57 Stratocaster → Marshall JCM800 (with light spring reverb).

Can I get the Daughter (Remastered) tone on a different guitar or amp?

Yes. Different guitars and amps need different knob positions to sound the same. GuitarToneAdapt models pickup output and wood brightness, then compensates so you match the record on your own rig.

How do I sound like Pearl Jam on Daughter (Remastered) — what gear and pedals?

Start with Position 4 (neck + middle), the amp EQ above (gain 4, bass 6, mid 7, treble 6, presence 5.5, reverb 2.5), and Fender American Vintage '57 Stratocaster → Marshall JCM800 (with light spring reverb). Then let GuitarToneAdapt compensate for the guitar, amp and pedals you actually own so it sits like the record.

Share this tone

Sources

Free practice tools

🎤 Online guitar tuner → · 🎶 Guitar chords → · 🎸 Guitar tunings → · 🎚️ Tuning chart → · 🎼 Guitar scales → · 🎚️ Chord transposer & capo → · 🥁 Metronome → · 🎶 Song chords → · 🎧 Guess the Tone game → · 🎸 Tone Legend quiz → · 📊 Tone data report →

🔥 The most famous guitar tones of all time → · 🎯 Easy guitar songs to play (with settings) → · 🗂️ Browse tone collections (by genre & language) →

More like this

🎸 How to get Pearl Jam’s guitar tone → · 🎸 more Rock guitar tones → · 🎚️ Marshall JCM800 settings → · 🎛️ best rock amp settings → · 🎸 more iconic guitar riffs → · 🎯 more percussive tones → · 📖 New to amp settings? What every knob does →

Settings are community-researched estimates, not official. GuitarToneAdapt adapts them to your gear. guitartoneadapt.com